Project guide
Deadlift Block Pair
Stackable pulling blocks with interlocking edges, replaceable rubber tops, and clearly marked height.
A premium DIY build should be easier to inspect, repair, and live with than the bargain version it replaces. This guide keeps the load path visible and the dimensions tied to your actual space.
Build the version worth keeping
Cheap DIY becomes expensive when it wobbles, frays, traps fingers, or gets rebuilt twice. Prioritize serviceable parts, smooth contact surfaces, visible inspection points, and a conservative test plan.
Failure could damage equipment or cause injury. Keep the first tests close to the floor, use a non-person load, and inspect joints and wear surfaces before every session.
Materials and tools
- exterior plywood
- internal ribs
- rubber mat
- carry handles
- Measuring, marking, and edge-finishing supplies
- Labels for date, intended use, and inspection notes
Build sequence
- 01
Plan the fit
Confirm the finished dimensions in your actual training space and mark all floor and wall clearances.
- 02
Prepare the parts
Cut paired parts together so the build stays square; ease every hand and shin contact edge.
- 03
Build the load path
Dry-fit the full assembly, then add internal bracing and mechanically fasten each structural joint.
- 04
Finish the contact points
Add the specified rubber, padding, or anti-slip surface and seal exposed wood against sweat.
- 05
Test and document
Check for rocking, exposed fasteners, and sharp corners. Load progressively before normal use.
Before the first workout
- Nothing rocks, twists, binds, or exposes a sharp edge.
- Wear parts can be inspected and replaced without rebuilding the frame.
- The load path uses rated hardware or professional fabrication where consequences are high.
- The finished footprint includes safe approach, movement, and fall or swing clearance.
- A first-use date and inspection interval are visible on the equipment.